shear

Been waiting to get around to figuring out what I did wrong with the HS40 going on the Powell. I knew timing was at the limit of the slots, so had some wild ideas about what I'd do to fix it. Since I have moments of zero pride, and am feeling humble, allow me to confess that when I pulled...

something i seen on youtube. maybe some of you guys would like to check it out.......:thumbsup: The Master Punch and Shear Tool - YouTube

Woodward Fab Throatless Shear and Mounting Board

Woodward Fab Throatless Shear and Mounting Board

Woodward Fab Throatless Shear and Mounting Board

Woodward Fab Throatless Shear and Mounting Board

So ever since it was new my milwaukee shear has had this problem of pushing off the nose cone. The design is bad beause it just crimps on and the aluminum gets worn and doesnt hold worth a crap anymore even on light guage material. So luckily there was plenty of room inside the body to put...

Im going to buy a bench throatless metal shear. Probrobly a woodward fab straight type. Id like for it to do thicker stuff and probrobly wont be doing alot of curves so i dont think i want the beverly / harbor freight style. what do you guys think ? heres the one im lookin at Woodward Fab Metal...

i have a 5hp briggs that i'm trying to get running. when i was checking the coil for spark, i removed the fly wheel and put a 1/2" drill on the shaft to turn it over. it turned over very easy, of course, and there was no restriction. when i replace the flywheel and recoil, it will start, but...