shortblock

Tecumseh H35 shortblock professionally rebuilt. this is a points and condensor block. Factory parts used throughout. Fresh .020 over bore, nos piston kit, rod and crankshaft. new gov shaft, crank seals, in valve, exhaust guide, recut seats, decked .025". ready to go. head, valve cover and intake...

New dual bearing cast iron bore horizontal shortblock. Disassembled but all there and new. 3/4 in. crank. 8hp. flathead. $100.00+shipping. Going another route. Thanks, Tim

shortblock/parts lot for someone wanting to do some building. these are the parts from a swap I just did, I changed the block/piston/rod out on a bike a recently bought becuase it basically needs honed or bored out, it ran killer, but was blowing smoke. the block itself other than that shows...

Ihahave a New Old Stock 5hp Briggs and Stratton shortblock for sale. If your briggs has let you down, this is the way to get a new engine without the expense of rebuilding your old one. It is a shortblock, so it lacks a head, carb/tank, flywheel and recoil assy. It is still in the original box...

I managed to find a brand new 1987 5hp short block. I have pretty much everything I need except the blower housing. I would like a NARP powder coated housing. I have only been able to find them back east and the shipping cost is expensive. Anyone know where to get them out west?

Briggs 5hp short block, used. starter clutch/ Point type crank, 3/4 tapped & keyed. No holes in side cover, has score on the flywheel side of the bore, otherwise excellent shape. Asking $75 obo plus shipping from Baltimore, Md. as-is Cylinder boring available for $45 extra

For sale is a NOS Tecumseh HS50 short-block. This shortblock comes with the original box, installation instructions, and gasket/decal kit. It is loaded with new block, piston assembly, rod, cam, valves, springs, and oil seals but no crankshaft. This would make a great replacement for your old...

Hey all, I picked up several boxes of NOS Briggs and Tecumseh parts. I'll try to find out what will fit the minis and give everyone here first dibs at them. I cannot find any info on this shortblock. It is a replacement number 80143A which replaced the 80143. Everyone shows it to be discontinued...

Was going to rebuild. That takes time and money. Seems like I always go down this road. $25. Located Brewster, NY 10509. Also going on ebay.

This is new and in great condition. It has a sleeved cylinder, DU bushing in the block, & Ball bearing sidecover. 3/4" Keyed PTO shaft. Looking for $75 O.b.o

jonnie101 | eBay

Tecumseh 3.5hp SBH 4317A Short block engine 3/4 shaft - eBay (item 280458474868 end time Mar-30-10 21:13:52 PDT)