stem

Tried to transfer the valve seals from my BSP head over to my UT2 head and the exhaust valve stem seal dose not fit. It is not machined for it either. Do I not run one on the UT2 head?

Hey guys, starting to buy replacement bits for my DB (currently at the powder coaters). I can't seem to locate a source for the steering bearings H.R.M.B.com doesn't stock them and OldMiniBikes was closed for phone calls, but I didn't see it on their site either any help greatly appreciated. Thanks

is the re a trick installing valve stems into the hole in the rim? i have the short stems with a seat roundness of about a little over .500" the opening in the rim is a little over .400" should i just grease it up and push it in as hard as i can or is there a stem with a smaller rim seat...

Looking to buy 410/350x5 tire and L stem tube that is in good shape with a good amount of tread left. Looking for a rounded tire like the CST knobby tire.

So on my trike the valve stem ripped out of the tube. It was a larin. Rather than buy a new tube I thought maybe it can fix. All I did was put a washer on the stem. it had a rubber coating on one side to seal against the bottom lip of the stem. It came with a bolt together fiberglass bath tub...

When changing a tire, I always try and use the original vintage tube as they are much thicker:thumbsup: The old dry rotted tires hold air but when I put a new tire on and re-insert the valve stem,......................Why does it always leak?:out: Is it because I am disturbing the dead.:laugh...

Can someone tell me the valve stem diameter from the older non hemi 212? Just need the number to check it against the valves I have in predator I just purchased a month ago. I think the newer 69730s have a smaller dia stem and that's why they won't work in my ARC high comp head. Stem dia from...

Top eye, stem, and bumper of a Sebac shock.

Does the stem on a HD Shortster to all the way to the top of the handle bars or is there a 3" space between the handle bars and the upper base of the front fork?

In my gx200 build I'm going with stock valve train with 1.3 rockers and 18lb springs from agk. Do I yank the intake valve seal to gain some installed height and prevent coil bind? Also I read that only the 160s have the seal...Truth? Are they important to have? Thanks!

Installing valve stem and mounting tire.

Installing valve stem and mounting tire.

Installing valve stem and mounting tire.

Installing valve stem and mounting tire.

Installing valve stem and mounting tire.

Installing valve stem and mounting tire.

Installing valve stem and mounting tire.

Installing valve stem and mounting tire.

Installing valve stem and mounting tire.

Installing valve stem and mounting tire.