Out of curiosity... has anyone got a decent design that would allow for a jackshaft and rear swingarm to share the same pivot point? I've been working to redesign the rear end of my MBX10 to include an extended swingarm and have some concern regarding chain slack as it relates to monoshock...
I have this Bonanza typhoon frame and swing arm that need to go. I will never do anything with it and maybe someone can use it. I hate to scrap it so I am asking the very reasonable price of $9.57 (because forum rules require a price) or about any offer. It is located in Clinton IN 47842.
I...
Some may know that I've been having a hard time like many of you fixing this problem. I just got back from the machine shop and after looking at my stuff they seem to think the most cost effective way is to make new plates to use a cheap aftermarket bearing and have a nice tight fit...
I am parting out my MTD Trailflite (approx. 1970)...This is one of the items for sale. This is the frame and will include the swingarm and shocks....not bent, but well used...80.00 shipped...check for more posts....Thanks, Frank.
Currently working on building this Quasi-Stellar frame. The only thing that is preventing me from finishing this build is the swing arm bearings and axle.
The axle is shot and I definitely need a new one. The bearings are a bit sad but I am not sure what I should replace them with. I believe...
boy did i relieve a lot of stress tonite......got the pics to prove it too.....i removed that bushing and the remains of the one that broke......i used a piece of pipe and a washer, sprayed a little rust pennytrator and a persuader and they both came out........yes.......i can do it....now if i...
I'm working on a '72 Rupp Enduro, and the holes in the frame where the swingarm bolt goes are slightly egg-shaped, letting the swingarm move from side-to-side. I see that the swingarm bushings have a jagged edge that I assume is to bite into the inner edge of the frame and help keep the...
I have a 1969 Frame, fork, and swingarm if anyone is intersted. You can pick it up or have it shipped for the actual shipping cost. I'm asking $100.00 becuase of the rules but will accept any reasonable offers. I will post pics later today. Perfect for a project bike.
****Swingarm and Jackshaft Assembly Sold ********
>>>>>> Bare frame available (pick-up only)....$25
Here's a Bonanza 1200 or 1300 frame with the swing arm and jackshaft still in place...has the rear axle adjusting eyes. Nice and solid and straight....no extra holes in the motor...
I am trying to remove the bushing that is inside the swingarm tube. Before I hurt myself or the part, does anyone have any ideas? It is a '68 Rupp and has front and rear brakes.
1200/1300 frame with swing-arm jackshaft, and footpegs. Straight and solid, no rewelds.
Located in Portland, Oregon.
Price... $125-145 shipped depending on where in the USA you live.
I think it's a swingarm from a Quasi-Stellar minibike, but I'm not positive.
It's about 12" total length, 8" wide, with 7" width clearance for tire.
Used, but in real nice shape.
$30.00 Delivered
(With a promise to try to make it to FunDay#3)
:scooter:CAN SOMEONE HELP ME ON THE DIMENSIONS OF THE BONANZA 1510MX FRAME AND SWINGARM ONLY VS THE BONANZA BC1200 FRAME AND SWINGARM. THEY LOOK IDENTICAL. WHAT IS THE DIFFERENCE IF ANY IN DIMENSIONS. THANKS GUYS!!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.