Anyone have a BB 6hp Briggs flathead disassembled? need specs on the piston rings

125ccCrazy

Well-Known Member
#1
If anyone has a 6hp flathead and a micrometer, if you could measure the width of each ring I need to compare them to a H70 Tec rings...I can't find any .010 h70 rings and it looks as though the Briggs has the same bore 2 3/4" which the rings can still be found... There are a few parts that cross over between the Briggs and Tec, hopefully these are one of them..
 

125ccCrazy

Well-Known Member
#5
Thanks Richard, after reading your reply I did a little more searching and I found the Stens rings are the same part number for both Tec and Briggs...Tec and Briggs had different numbers but Stens number were the same.... I'll order the Briggs rings.... Thanks again...
 
Top