Crankshaft drill guide

[Roadrunner]

There are numerous posts over the years of members that were going to, or did, or planned to, I think OldMiniBikes even used to sell them..... but does anyone have a crankshaft drill guide for a 3/4" shaft to drill and tap a crankshaft. Willing to rent it, pay postage, whatever,,, would love to hear from someone who has one.

 

[Fantic Freddy]

Did you ask OldMiniBikes member "metal man"? I talked to him, he plans on making some.

 

[metal man]

Crank guides are on the list to build . Needs to warm up some to get out in the shop 13 below zero sucks . So how many are wanted lookin at making a dozen ??? to start with. On the cost lookin to be around 20 or so . Any ideas or thoughts lets hear it out there

 

[Roadrunner]

I will definitely buy one, have a nice useless engine just waiting to be put on a mini, $20 is fair. This comes up occasionally on the OldMiniBikes< so I would think you would sell all you make eventually.

 

[BBQJOE]

I might be in for one.

 

[older then dirt]

Count me in for one! Been needing one for a while.

 

[manchester1]

Count me in for one.:thumbsup:

 

[metal man]

Ok they are on the list just have to warm up some and get the steel prepared.

 

[RobertC]

I realize this is an old thread.

Does anyone have one of these for sale ?

Thanks !

 

[cfh]

you can buy the part to do this for $10 from McMaster Carr.
http://www.pinrepair.com/minibikes/tecumsehmb.htm#drillpto

 

[RobertC]

Hey thank you @cfh .

My current project is 5/8th inch shaft. So I'm going to see if they carry a 5/8 od drill bushing.

Thanks.