H 50,60,70

6doggie3

Well-Known Member
#1
Do the bolts that hold the mounting plate to the engine need to be sealed so the motor doesn't lose oil?
I took the plate off an H50 to use as a template about 1 1/2 mos ago and once the temp got a little bit warmer i notice oil coming out one of the bolts holes and hasn't stop?
 

125ccCrazy

Well-Known Member
#3
The holes don't protrude into the crankcase unless someone used too long of a bolt and punctured the case at one time or there is a crack from over tightening...if it's leaking around a bolt I would inspect the block inside and see if there is a crack or other damage.
 
Top