So I got a h50 off capguncowboy(thanks Andy) nothing wrong with it but being dirty..also it’s a lighted cast iron sleeve engine....so I wanted to try my hand at this one...couldn’t find any fancy billet parts to put inside so went with all new stock parts....new stock piston .010 over rings and cut them down....new rod all new seals and a header supplied by OND(thanks eric) and a 22mm mikuni carb...I have two intakes a straight one from eric and I purchased a right hand angled off 125cccrazy(thanks Randi) not sure which one will fit the place I’m going to stick this one so I wanted both to be safe....i honed the block with a 400 grit flex hone....and cleaned up everything so this weekend will be assemble time....more to follow...
Attachments
-
117.1 KB Views: 41
-
82.8 KB Views: 43
-
93.1 KB Views: 49
-
97.3 KB Views: 50
-
100.5 KB Views: 51
-
97.4 KB Views: 47
-
108.7 KB Views: 51
-
116.4 KB Views: 51