Help

#1
Can anyone tell me how to get a Teel Pump off of a Briggs Engine and how it is connected

All bolts out, don’t see any set screws, don’t want to damage and not coming off. Thank You
 
#2
Can you do a pic? What HP ect...
Its a water pump engine so you most likely will have spline crankshaft.
Water and goo corrosion might be on crank and holding it togerther. .WD 40 soak for few hours or more.
 
#3
Can you do a pic? What HP ect...
Its a water pump engine so you most likely will have spline crankshaft.
Water and goo corrosion might be on crank and holding it togerther. .WD 40 soak for few hours or more.
Can you do a pic? What HP ect...
Its a water pump engine so you most likely will have spline crankshaft.
Water and goo corrosion might be on crank and holding it togerther. .WD 40 soak for few hours or more.
Thank you. I will take photo tomorrow. Was hoping it wasn’t spline son was all excited. Picked up complete assembly for free mounted in carrier
 
#5
I was able to get it off tonight. The piece was screwed onto the crankshaft and to my surprise came off easily. I ended up looking up the engine to see the end of the shaft. It will keep my son busy for a while, have a carb just need to find a gas tank. Thank you for your response.
 

Top