Hello again.
min need of a correct jack shaft for a Bonanza BC. looks like the shaft was spinning in the inner bearing race. It’s very loose on one side in the new bearings. Also interested in gears if anyone has them.
Thanks in advance!
BMI is where I got mine. I had to buy it extra long, and then cut it to proper length and then machine circlip lands in the ends to make it work like the original...but any machine shop can do that.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.