Ok , finished up my project and want to wire up a kill switch. I don’t know too much about them. I’m using an older Briggs 5hp flat head . I bought a one wire switch and connected to the area in the pic. It’s not working. I assume I need a ground .
Ok , finished up my project and want to wire up a kill switch. I don’t know too much about them. I’m using an older Briggs 5hp flat head . I bought a one wire switch and connected to the area in the pic. It’s not working. I assume I need a ground .
The tab on the side of the coil should go directly to ground.
Also, be careful about winding that engine's rpm up. The flywheel has a missing fin. You don't want it exploding on you.
Ok so you’re saying there is a tab on other side? Do I stay with a one wire switch or go with one with a ground wire? I’m gonna get a new flywheel too.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
