my project is my gemini scrambler, made by San Tong Co. it suposed to look like my avitar. i have waiting to get it from delaware down here to georgia and i got most of it. some remaining parts are being gathered up by my brother and shipped. i have been busy collecting up metric bolts and ball bearings to re-load the forks back in. it seemed to take 18 1\4 inch balls in the bottom end and 23 3\16 balls in the top. the TC unit is gone, it looked alot like a rupp unit, but i have a used 30 series comet that looks like its going to fit. i just need two 5\8 x 1 3\8 bearings with the snap rings on them to load the jackshaft back in. i have a hs50 tecumseh to go on it needing some carb work thats in progress. this bike has been apart for about 20 years so all the hardware is gone and some small parts, but its starting to look more like a bike!
the biggest problem i have is my wheels are lost. i need at least one 10 inch spoke rupp style wheel or even just a hub. i realy need two, but i could use a different one i have for the front even though i dont want to. anyone out there have a wheel or two? even in bad shape?-phil
the biggest problem i have is my wheels are lost. i need at least one 10 inch spoke rupp style wheel or even just a hub. i realy need two, but i could use a different one i have for the front even though i dont want to. anyone out there have a wheel or two? even in bad shape?-phil