OK...so i got most of the wheelie bars done. I just ended up welding some nuts on the bars to put some clevis pins through. I was trying to find something U shaped to weld on.. but no go. I didnt feel like searching all day or surfing the net too long. After i drilled the wholes for the wheelie bars on the tabs i made( and almost popped a tire) i put it on and pushed the pins through.. had to do a little twisting to get it on. Now that its on i will finally weld on a cross piece to get it square with the bike tabs. All this took a while.. had to do a lot of bending and rebending to get things straight when i was originally welding it up.. i dont have a whole lot of tools at my disposal to keep everything straight. The pin by the chain is going to have to be cut shorter and double pinned. The best part is its removable and it doesnt make turning any harder. wheels are about 2 inches off the ground.