Old school-retro aluminum LEFT brake handle 7/8"

Rapidrob

Rapidrob

#1
#1
I need a 7/8" handlebar size white aluminum L E F T brake handle ( hole for cable "barrel" will be aiming at the ground)
Like this one but for the left side. From cable lock to ball end is 7 1/2" long. I need the whole assembly as the handlebar cast aluminum pivot point is cracked in half where the screw is. The pull handle is OK.
brake handle.jpg
 
Charles S

Charles S

#2
#2
Look for a motorcycle clutch lever assembly (AKA: lever & perch), there are billions of them. Be sure to check the barrel hole size if you need to match a cable. There should be plenty of inexpensive ones made for pit bikes, plenty of expensive billet ones, too, if you want to splurge.

I'd start by Googling "pit bike clutch lever assembly"
 
You must log in or register to reply here.
Top