PVL Aluminum Flywheel & the Hemi Starter Cup?

#1
Guys,
I just measured the height of the Loncin Predator Hemi 212 starter cup on the original cast iron flywheel, & then measured the same starter cup on my new PVL aluminum flywheel. The PVL set-up is 0.195" lower. I still had the crankshaft in the block, so I installed the PVL flywheel & the starter cup, adding the fan cover & recoil starter. It seems to lock up and turn over the engine , just fine. Does anyone see any issues here? I take it the rectangular openings in the starter cup are long enough to allow the change in the height?
Brian
 
#2
Should not be an issue, I use PVL flywheels on almost all of my builds (clone, and Predator) and have never had an issue
 
Top