I have a CT200U-EX. I was disappointment with the low end power. I put a 72 tooth sprocket on it and got a little more but still can't pull me up hills from a dead stop. I'm losing weight but am still 215. I want to pull deer so even more low end needed.
At the suggestion of the members here and pretty much all internet advice, I installed a torque converter from GoPowerSports last night. I only rode it around for a few minutes as it was late. It did seem to pull me up the ditch just a very small amount better.
But, if i ease through the throttle, even on flat ground, it doesn't start pulling until I'm pretty deep in the throttle, like half way. Is this typical for TC's? Should I open
At the suggestion of the members here and pretty much all internet advice, I installed a torque converter from GoPowerSports last night. I only rode it around for a few minutes as it was late. It did seem to pull me up the ditch just a very small amount better.
But, if i ease through the throttle, even on flat ground, it doesn't start pulling until I'm pretty deep in the throttle, like half way. Is this typical for TC's? Should I open