Removing governor on your engine and OldMiniBikes !!! Please read !!!

Li'l Popeye

Well-Known Member
He says the coil is still held in tight while he jiggles it with his hand. Never mind where you can see that the coil has been riding on the flywheel.
He unscrewed it before he jiggled it.
Unlike the video title says the flywheel is not blown. It just lost a magnet. It must have hit something before it came off.
 
but is the damage by people droping them or hit it with a hammer and puting it back on the motor
The issue is the flywheels aren't rated for the rpms an ungoverned engine can pull. It's not even the flywheel coming apart half the time, it's the magnets coming off of them which still messes some shit up.

There's not a chance in hell I'd run a stock flywheel on one of my engines that's pulling over 7,000rpm. I don't even like running a stock flywheel on an ungoverned stock engine.
 
right tool for ever job you dont beat it ,went you remove the govrneder it not a pass in the fast lane your motor will kick my motor ass i got hf shit so down hear in gas monkey garage we glue shit with gorilla glue for magnets
 
Top