snap ring style axle ??? Bonanza

[CrossleRacer]

Hi, I'm rebuilding my bonanza jack shaft assembly. The jackshaft/axle are all good. However the 5/8" axle bearing that uses snap rings is beat to crap. So I have to replace it. I can find millions of keyed jackshafts, but why can't I find a 5/8" axle bearing that uses snap rings and no keyway- which supports the jackshaft arm.

I need it to be 5.8' diameter and 24mm or 9 1/2" long with snap ring fittings at the end. Help or advise appreciated. Thx, Paul

 

[Skipp]

BMI can specially make one to your specs…even put in the snap ring groove…about $35…I’ve never had luck just locating one of those swing-arm shafts ready made…

 

[Fulltaxim]

"about $35 " I really don't understand if it's only about $35 why are you "I’ve never had luck just locating one of those swing-arm shafts ready made… "?

Sonic exe​

 

[Skipp]

Because they are a S P E C I A L - O R D E R! There spelled out for you…..

 

[canuk]

I have used a tube cutter to cut grooves in shafts for snap rings

 

[CrossleRacer]

I'm all set here- i purchased one. thx, paul