Tri-Rod Torque converter upgrade

#1
Hey everybody need some help maybe if somebody has a picture that would be better I have a Tri-Rod I Will be upgrading to torque converter . Does anybody have a picture of a jack shaft set up that would start me in the right direction thanks for any help you can provide
happy Fourth of July Jeff
 

Cuda54

Active Member
#8
Boneyard$ on the bottom of the jack shaft mount the slots are for tightening the drive chain. Then you adjust the drive belt what size engine are you putting on?
 
#10
Here is the best pic I could get without taking the body off of it. I'm running a 40-series with no back plate on a Duromax 440cc on my Tri-Rod. The jack shaft setup is very similar to the picture Gumpit posted above. I had to measure the distance from the crank to the jack shaft and order a longer belt, but it works flawlessly. My tri-rod has the rear suspension so I had to lift the motor about 2 inches so that the driver would clear the shocks.
IMG_20190809_222900.jpg
 
Top