Hey Guys, I was given a Doodle Bug DB30 Baja 97cc engine mini-bike the other day. I have cleaned it up (somewhat) as it had dirt dauber nests all over and in it. I cleaned the carburetor but couldn't get it to run. So, I ordered a new carb along with the throttle and cable off Amazon. Carburetor was no good, so got the replacement today. I got the bike running, but can't figure out how to adjust the throttle and governor. Can anyone show me some photos of how the governor is supposed to be adjusted? If I decide to keep this thing to ride around the neighborhood, I will need some new tires. The kids that had this thing had parents with money and didn't take care of it. I need to change the oil as it's black as the ace of spades. What weight oil should I put in it? I have a new rewind ordered for it as the spring broke inside it and the crank rope broke on me when I tried to crank it. I have cut the coil spring off and heated it so I could make a bend in it and replaced the rope. I don't know how long this spring will hold up, thus the new one is ordered. I had to clean the rust off the flywheel and coil and set the air gap at .012. Is that a good gap for this engine? It seemed to run pretty decent one I tried smoothing out the carburetor, but the governor was not connected and I'm not sure I got it right. Obviously, I don't have it right or I wouldn't be asking, right? Anyway, any advice on how to properly set and adjust the governor would be GREATLY appreciated. I had one guy on another forum tell me to just remove it, but I don't like that idea and don't see how it would even run without it.