canuk's latest activity
-
Ccanuk replied to the thread 2-Speed clutch problem.measure the clutch if its 3inch wide you need a 3 inch pto if you look at your picture you posted the shaft is to short,the pto has to...
-
Ccanuk replied to the thread 2-Speed clutch problem.I measured the clutch its three inches wide if you put it on a 2 1/4 pto it will be 3/4 inch recessed in the clutch,it cant work the...
-
Ccanuk replied to the thread 2-Speed clutch problem.just measured one of my fox clutches its three inches wide you need a three inch pto
-
-
Ccanuk replied to the thread 2-Speed clutch problem.when you put the clutch on the pto shaft should extend slightly past the clutch,the washer rest directly on the shaft when bolted down...
-
Ccanuk liked Studeman68's post in the thread rupp ,turbines , fenders , Tecumseh ,carbs dogbone muffler etc mini bike stuff.Possibly this fella? https://www.truepeoplesearch.com/find/person/px282llu2844u80829u08
-
CThanks for the tips. I will take onto lawn to start, this way it won't mess up the paint if it gets away. Plus I'll lube a little more...
-
Ccanuk liked Robertt8883's post in the thread rupp ,turbines , fenders , Tecumseh ,carbs dogbone muffler etc mini bike stuff.I fell for it lost $206 but its going to hit him hard when he doesn't expect it.I will let you know when and what happens !
-
Ccanuk replied to the thread Be careful....Lots of scammers.you have everthing just build a bike
-
CMy son and I completely restored (including a completely rebuilt engine) a 1968 Taco 99 a few years back. The engine was a 1972 Briggs...
-
Ccanuk replied to the thread Be careful....Lots of scammers.I find it funny when they get caught there all the same.The pity me Im a new member shouldnt be treated like this.Then they reverse the...
-
Ccanuk replied to the thread 2021 build off 1968 Taco 44.I know its a little tight when i was installing the pegs I started with 4 inch,orignal is 2 1/4 cut the left down to 3 tried it it...
-
Ccanuk replied to the thread 2021 build off 1968 Taco 44.had to make a brake lever used a azusa arm it has a double square ran a weld on both sides and filed the rectangle.made the wheel...
-
-
Ccanuk replied to the thread Wanted : K&H Caliper actuator pin.blackwindowmotorsports sell push pins for caliper.
-
Ccanuk replied to the thread 5” Taco wheels.theres a pair on ebay
-
Ccanuk liked fastvintage69's post in the thread rupp ,turbines , fenders , Tecumseh ,carbs dogbone muffler etc mini bike stuff.turbines no cracks 65 ech shipped digger fenders 200 shipped dog bone muffler 100 shipped angled carb adapter 65 obo Tecumseh hs35 tins...
