f4radar's latest activity
-
Finished my 1968 Mickey Thompson Mickey Bike. Had the 68 Briggs block bored .010 over than I rebuilt it. Front spring and bars I had... -
i had an HS40 once with a worn crankshaft rod journal. the engine went through hell with low oil, and it threw the original rod through...
-
the position of the 4 leg pull start mounts is dependent solely on application. Minibikes with flat motor mounts will have the pull...
-
f4radar replied to the thread Help Dating a Tecumseh 3hp.Dating a Tecumseh 3hp can be tricky. They like to go to gas stations but you have to ask them nicely. Pull the rope gently and...
-
https://www.theguardian.com/music/2025/jun/11/brian-wilson-beach-boys-dies Rest in peace brian. Hope theres sunshine surf and pretty...
-
Success!!! Using the "Hot Sand" method for Plan A, I was able to make a slight bend above where the hold down bracket clips on. Heated...
-
-
f4radar replied to the thread Minor Technical Difficulty.You could "slim down" that dipstick by taking a little material off each side.
-
I like the heat/angle option or just tap the cover and use a threaded oil fill plug.
-
f4radar replied to the thread Minor Technical Difficulty.That's it, heat with heat gun, and bend.
-
-
f4radar replied to the thread Minor Technical Difficulty.Maybe cut a section out of the middle, heat up the ends to get the plastic melting and press them together, seal it up with some heat...
-
f4radar replied to the thread Remembering Memorial Day..That time of the year again.
-
Try a paint less guy ,the access is pretty good so I bet they can handle that quickly
-
Just ride it already