Recent content by grumpyed

Mini Bike & Go-Kart Parts

  1. G

    long shot

    need a gas tank for one of the following,79-81 suzuki ds100 or ts100 or a 78-80 suzuki rm100/125
  2. G

    Bearing Source?

    AMAZON.i GOT A 10 PACK FOR ABOUT $16
  3. G

    Will this engine fit in my ct200u ex???

    Its a bolt in but the specs they show for torque makes it a 6hp.
  4. G

    sachs 80b

    it may be the flywheel.have you used an indicator to check crank run out?
  5. G

    Bottom half of the frame acts as a swing arm?

    poor thing never knows what the rake and trail is going to be at any given second.
  6. G

    SST 80 Boss

    Yamaha yg1 is the patter for that engine.ebay should turn up those parts.
  7. G

    AH47 recoil part #

    it takes a fairbanks morse starter.you can finde one on most of the old chainsaws that used PP engines
  8. G

    Can anyone identify this engine? Salsbury maybe?

    Exactly.Probably from a concrete buggy.
  9. G

    Chrysler 58011

    it probably has a splined shaft
  10. G

    Looking for a reasonable priced headlight

    AMAZON SHOULD DO IT.
  11. G

    Freak-Bikes, Homemades, Customs, Frankenbikes & Oddballs

    THAT REQUIRED A LITTLE THOUGHT AND A LOT OF BEER.
  12. G

    Baldwin trail cycle

    need a clutch and chain
  13. G

    New member with a 1976(?) Nighthawk

    bad pcv valve.worn rings,over full,all of the above.
  14. G

    WTB Rockford Chibi / Tora carburetor rubber cap.

    look up rout 6x6.I think he still deals in those bike parts www.route6x6.com
  15. G

    1972 Suzuki rv90 engine swap

    might as well just build the engine you have.check the reed valve condition,cut the spark arester off of the silencer[ the turbin looking thing ]bore to 100cc,rejet carb,re gear to suit.its already 8hp in proper stock tune.
See more
Top