Recent content by WERNER1

Thanks for pulling this thread up (It's not t h a t old... :D ) ... This past winters project was rebuilding and beefing up the 9" rear end in the Torino. I just finished that up last weekend so hopefully I'll get back on the mini bike soon - I picked up a new welder too so I'll be itchin to do...

Yeah that's the one I'm talking about,.. some serious craftsmanship there!

I'll probably just try the sand fill method ... I'm sure it'll work fine with the smaller amounts of tweaks I need to do. I'll post some pics..

Yeah I bet that thing ran like a scalded dog!!! That's sort of my plan with this one - This coming spring (or sooner if I sell my street bike) is to buy the Edelbrock Top end kit ( #2090 ) $3800.00,.. which is 460 hp on a stock 9.0:1 compression motor - so upwards around 500+ HP @ 10.7:1 .. ...

She's a 69 Torino GT Fastback "M" Code - 351W 10.7:1 Comp. / 4V - Bored .030, Balanced, Cam, Studded Heads with Roller tip rockers & Stainless valves w/HD Springs. Performer RPM w/ Holley 650 DP. & Dougs Stainless Ceramic coated headers... 5 !?!?!?!? I thought I had issues!! haha! Pure Stock...

Haha,.. I know right!?! .. I could send it back, but honestly it's pretty close just needs tweaked in like two places I think to make the bends work with/around the frame. Was too busy working on the kids 97 F250 this weekend to mess with the mini bike,.. maybe this coming weekend..

Thanks for the replies guys! I think I'm wanting to stick with some sort of "Plastic" seat base so when I do the seat cover I can staple it into the bottom of the plastic seat base - I've done many Motorcycle seats over the years and the bases of those are "Plastic". Good suggestions on the...

So I've go this Puma 200 build that I'm working on and we're putting a new Predator 212 in it. I picked up a Header pipe & Muffler from Go Power Sports for it and it's supposed to exit out the rear under the seat... Well my frame isn't playing along with that plan and I'm going to have to...

Thanks! I sort of mentioned this in the original post,... my plan is to utilize the seat foam and cover from the new MB200 seat I have. But I need to make a "Base Plate" for the foam to be glued to and also to staple the material to on the bottom side. As far as attachment I'm thinking about...

Good to know,..there's a Michael's close to me so I'll have to check it out..

A few more pics...

Hey guys,.. I'm in the process of this Puma 200 build and I'm having trouble nailing down where I want to go with the Seat portion of it,.. I purchased a MB200 seat thinking I could mount it back further on the frame, but it turns out it real lo y only lines up more forward like on the...

Okay I was finally able to get this part of the project completed today, yay!

I did remove a little bit more material from that front leading edge "Stop",.. the kick stand comes forward just a tad more now. I was able to mock it up in a vise last night with the spring and it feels nice and solid in both positions. I also mocked it up on the frame and it looks like the...

And then here is my idea on the spring retaining stud for the bracket. Basically threaded a 5/16 hole and used a bushing collar that I will weld pretty close to where it is place now. I'll also weld the bolt to the plate and cut the excess threads off. So hopefully the angle is great enough when...