Yes it’s a 212 and no didn’t use plasti gage because I knew the old bearings were shot. It’s fully built other than a non billet stroker crank and stock side cover. I am wondering if I slap a stock 212 crank in it if it will make enuff compression? I have plasti gage somewhere I will check the...
I have a built 212 I bought on marketplace and I got new crank journal bearing because there was play and now there is less. Wondering if this is normal? Should I get a new stroker crank? Not sure if it’s a 56mm or 58mm but I will check tmr. Can i temporarily run a stock 212 55mm crank and have...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.