engine!!

[ttapa207]

looking for a briggs 5hp flathead. 8hp and 6.5 hp briggs too. i need em cheap and unless in maine shipped. working or not.

 

[miked]

i have a great 5hp and a great 8hp $175 for both dont have pic of the 5hp but both run great

 

[ttapa207]

could i just buy one?

 

[miked]

here is the 5 hp for $50 has a backward position for the pull starter but runs great and sounds really good bike pulls hard when gassed have never rode yet because have no kill switch and dont like throttle return spring setup putting an 8 hp on it .020 over piston cast iron bore dual bearing motor cam with valves and springs should be pretty fast can take better pics if you would like

 

[125ccCrazy]

6.5 Intek

I have most of the parts for a Briggs Intek 6.5 dual bearing, steel bore, I have the block, side cover, rod,piston, flywheel, coil and head.... I have the crank also but someone trashed the clutch end with a grinder before i got it, everything else is good....

 

[miked]

here is the pic with the engine off the bike