Low oil sensor on mmb212 pro removal?

[Nathannewbie]

Hi all,
As most know, I have the mmb212 pro. Anyway I would like to remove the low oil sensor and I constantly leave it on uneven ground for short periods of time (1-2 minutes) to dismount and do stuff. I hate that it dies within 30 seconds and takes 5-6 pulls to start again. Is removing it any different than the predator?
Help and suggestions are welcome.
Thanks,
Nathan

 

[SAT]

Hi all,
As most know, I have the mmb212 pro. Anyway I would like to remove the low oil sensor and I constantly leave it on uneven ground for short periods of time (1-2 minutes) to dismount and do stuff. I hate that it dies within 30 seconds and takes 5-6 pulls to start again. Is removing it any different than the predator?
Help and suggestions are welcome.
Thanks,
Nathan

Idk about your particulars, but we cut the sensor wire near the sensor and cap it on all of ours.

 

[Nathannewbie]

Idk about your particulars, but we cut the sensor wire near the sensor and cap it on all of ours.

How do you cap it??? So all you do is just cut the wire??

 

[SAT]

How do you cap it??? So all you do is just cut the wire??

Most have a connector, I’m unclear as to the exact terminology, that can be disconnected and shrink tube capped. Or just cut and shrink tube capped. About an inch of tube and 1/4-3/8” overhang and put the heat to it.