Ok, I need some help. I bought a Coleman CT200u used. Had been sitting for years. Cleaned out the fuel tank, put a new carb on it and got the stock centrifugal clutch unfrozen and it ran fine. Pretty slow and the clutch slipped going up hills so I put on a TAV.
After the TAV install it was just...
Hey guys. Picked up a Coleman ct200u for a song and am starting to modify. I want to use it on BLM/forest service ground along with private Property where wild fire is a risk here in CA. I’m thinking of getting it green stickered but haven’t decided.
I’m coming up short on the best way to add a...
You guys are good. So this is the deepco driven. Looks like maybe all I need is the driver to get this going.
Is there anything I should look at or check on the driven? I see there is a snap ring on the back side I assume this is to take it apart.
Thanks
Yes this is a tote goat style bike.
This is what came on the bike when I got it. With a centrifugal clutch on the motor and it didn’t work very well. I’m assuming that v belt pulley is not correct.
Thank you for the help
I looking for a tav for my blazer mini bike. Im gonna run a gx160 with 3/4” Keyed shaft but my driven jack shaft is also 3/4”.
All of the tav I come across are 3/4” driver and 5/8” driven. Do I need to go to a 40 series and try and bush up my motor shaft to 1”?
Thanks
JW
No driver. This is all I've got. This is my first rodeo. What's a button? Also I assume I could get a driver that matches the shaft size on the engine?
Hey everyone. I've had this for a while but I'm getting ready to start gettin it fixed up and back out on the "trail".
All I can really find for info is some old ads and a few pics.
When I got the bike it had no motor so I put a brigs that I had with a centrifugal clutch on it. Was this bike...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.