Recent content by SouthernLand

Thanks delray, only reason I’m sticking with the small sized block is because the billet bell housing on my mud motor frame, it’s bolt pattern is the 4x whatever predator back plate is. I was curious about the 301cc predator which is a big step up in hp but not sure if it has that same bolt...

https://www.eccarburetors.com/EC228R-NEW-EC-228R-Racing-Engine_p_1794.html

Thinking of just pulling the plug on getting this motor instead of hopping my predator Hemi up. anyone have experience with this ec built motor? Any input would be appreciated Will post link

It was an issue after the first time I took the boat out. Deleted it

Also delray which throttle cable end do I need for that chikuni think I’ll need a 70 inch one

Oh yea, I’ve run it a few times, it gets up to 9mph quick but not a damn bit faster -.-

That is what I’m Working with. And I use stainless prop not aluminum

What is this??

Would love a link! All I see on amazon say does not take mikuni jets :/

Thanks for the input delray, is they’re a certain brand of chikuni you prefer? Have a link for the one you used?

Also out of stock there aswell

For months I have been searching up and down countless sights and pages on google, I cannot find a genuine 22mm mikuni. (VM22-133) they have the Chinese knockoffs everywhere but I want the real deal, pay for quality the first time. I have been so tempted to pull the plug on a 24mm mikuni as it’s...

Vm22 the genuine mikuni carb, everywhere on the internet is out of stock