Search results

  1. S

    My clone runs like crap :(.

    I recently acquired a never ran lifan clone motor. After getting it assembled and setup, i could not for the life of me get it to run. After many hours, I discovered, if quirt fuel directly through the carb into the engine, fully engage the choke, and open the throttle up I can get the engine to...
  2. S

    fS: Comet 44 series TC, 3/4", 18hp, never used, 2 belts

    For sale I have a Comet 44 series torque converter. Driver is 3/4", driven is 5/8", Up to 18hp, never been used, and comes with two belts. It is in perfect condition, just like I got it out of the box. This setup cost over 340 bucks brand new, it would be perfect for those of you who have a high...
  3. S

    Anybody want to trade 3/4" Comet44 for a TAV2?

    I have a 44 series comet TQ converter setup that I was going to use in a go kart project, but I have lost interest. The drive pulley is 3/4" and the driven is 5/8". I also have 2 belts. This setup has never been used, and is good for up to 18hp. This setup cost $340 new, plus delivery:doah: I...
Top