Search results

got the 1.8 from Niche Cycle...same result (flood). I think this motor will end up in a gravity feed switch anyway.:scooter:

eBay piece from Taiwan figure it will be ok until I decide what to build or stick it in,:thumbsup:

I saw the other photos it looks like a torqueaverter. Great build.

That thing is bitchin. What size sprocket in the 50s? Bully clutch?

Thanks! What should I build to stick this to? Kid-size Chinese quad? Full cage kart?

Here it tis...sounds awesome, but dumps fuel out of the bottom overflow AND seems to run better without the mikuni fuel pump (Gravity feed). Is this the case with a mikuni flatslide? Is there a workaround for a karting/atv application requiring a fuel pump? Thanks

Yup! Sheared like a sheep. What size woodruff does it take? BTW thanks youse guys!:thumbsup:

saw some postings about that...lemme check

yes it's fully-retarded. I was just trying to void p.o. any special-needs members on the board:laugh: I also set it on the middle and fully-advanced settings, but not go.

Hey all. I built up a 420 and installed a 34 mikuni flatslide with mikuni fueld pump and ran it at idle to break it in for about 20min (NR racing recommended). I revved a few times and then i conked out, now it wont start. I forgot to tighten the adjustment bolts on the flywheel (ARC) and it did...

I have the ARC with the ring gear and I can't find the little piece of paper with the proper gapping number? Little help:shrug:

:thumbsup: thanks for the guidance

I have a 420 that ran for about 5 hrs on my homemade generator rig and I'm going to build it up. I've done 3 212 builds so I have a decent feel for what I want to do. Can you all provide some suggestions on what to keep/sell? I've broken the whole piece down to the bare block and removed the...

I checked the level and it's OK. Not a lot of oil, but the spots are annoying. I have a dirtbike stand that will keep it level, mebbe the tilt of the kickstand makes it leak past the fill plugs? Either way, thanks for the input.

Anecdotal, can't remember...seems like it's incorrect based on the responses thus far...

I looked for a sticky, but thought I'd ask. Will it return to production?

I recently moved to Redline oil after break-in on my modded predator and I'm noticing oil on the floor. Realizing there are many factors, one of which is the fact that synthetics do creep past seals, do you all have any hints/tricks. I don't mind living with it and topping off on occasion. I'm...

I would agree with the low oil sensor (easy fix), but maybe it could be you are too lean carb? Can you run with the choke all the way off?

Will sell roller including brake and throttle hardware for $225. Rear is 12x6x6 slick on 6x4 tristar. Would sell frame alone for $115. Local pickup or can ship from 19090 zip.

I'm running 26 white stripes and some similar components to you, but I haven't been able to stay in it long enough under load to shake it out. TAV and the sidecover are $$$, but I'm sure they help durability with repeated runs.