I was wondering if the noram cheetah clutch has a horsepower range/limit. Hoping for close to 20 hp with setup I am running. I am not sure if the 2 disk is enough or do I need a 3 disk. Any info is appreciated.
View image in gallery
Looks like the center line of the contact point is further away from the stud than my stock rocker. I know the push rod side is shorter because if the 1.2 ratio but the valve side should be the same distance right?
Okay I am running into a few problems , I removed the 160 lifters and put them in my predator I cannot seem to get it any lengths that seems to work I get the shortest lifters and rods I have there either too short and don't work or the ones that do work still hit the top of the lash cap. It...
Think I am going to try the 160 lifters then I will have two length lifters and three length rods to try and get something of a overall length needed, thanks for any and all help
Do you know of any easy ways to get the measurement for the links pushrod I need or should I just buy the cut to length and take a little bit off at a time until it works
If I reinstall my stock rocker arms instead of the 1.2 ratios billet arms it seems to put contacts on the right part of the lash cap. Is this wear do you to just running different ratio arms
I am trying to build a predator 212 drag motor for minibike I'm running a 285 series cam from nrracing with chrome Molly pushrods billet rocker arms and also have stainless steel valves from nrracing the lash caps I installed seem to be wearing a little funny and I noticed that the rocker arm is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.