Search results

History: Barn find early 70's Arctic Cat Whisker with Sach's engine. Was able to clean her up enough and did 2 laps with it then it stopped running. Pulled engine off minibike opened her up on my workbench cylinder head damage cracked ring. Was able to source new cylinder head with rings but now...

Sachs / Saxonette (Arctic Cat Whisker - Rebuild) won't start- Please Help ! Ok had the Arctic Cat Whisker running 'till the pull start went then it was buried in the back of my shed... Now she's back on my workbench as my son (now 9) asked if it'll run ? Here's what I've done so far : 1...

Ok had the Arctic Cat Whisker running 'till the pull start went then it was buried in the back of my shed... Now she's back on my workbench as my son (now 9) asked if it'll run ? Here's what I've done so far : 1. removed all old gas from tank 2. removed & cleaned carb (Bing 1/12/1670)...

Where exactly is the head gasket located ? Is it at the top most section of the engine ( 4 bolts hold it down ) or is it lower where it tapers into the carb area ? I don't recal seeing a gasket when I removed the top most portion to inspect the cylinder head ... this may be my low compression...

O.k. now that I've identified that there's a compression problem (too low) what are my next steps ? How do I correct a low compression problem ? is this something that a joe hack like myself can do or do I need to send it out ? cost ? and any other opinions that you can share ... I'm all ears...

Still suffering from no top end power even after the carb rebuild (making gaskets was a challenge). picked up a compression tester and registered some dismal numbers (less than 100). Next step the reed valve unless someone else has a better idea. If you know where I can find one please let me...

I just rebuilt the carb on my '72 Arctic Cat Whisker and still experiencing loss of power at the top end. Does anyone know what the gap should be set at on the spark plug? Please advise,

My Arctic Cat Whisker is running a little rough ... it pulsates ( with the throttle fully opened ) it revs up but won't sustain or go into second gear. It just starts to rev up to higher rpms for only half a second and then it returns to cruising along in 1st. I'm thinking it could be a top end...

O.k. let's face it without this website I wouldn't be embarking on such a task. So kudos to everyone for giving me the opportunity to give it a go ! I noticed I'm missing a "kill switch" for the bike and 1(one) brake pad (looks like the Bendix type) -what type of switch can I use for a...