Search results

  1. Piezak

    My Heald Hauler

    Change this. I received that fuse block and it wasn't water proof and also I could only have one power source be the input for all legs. So, I've bought another. This will allow different power source inputs as needed. Scratch the diode. I am not going to use a diode. I don't want concerns...
  2. Piezak

    So what are you welding with? (Post your set up here)

    How is yours hooked up? I have 2 hot 110/115v legs ran to the garage with #6. I was thinking of a 50A plug.
  3. Piezak

    My Heald Hauler

    I just bought one of these. I'm thinking of adding/upgrading protection to .... 1) Headlights, Tail 2) Turn, 4-way, Brake 3) Overhead Strobe 4) Horn 5) Starter Solenoid 6) Rectifier/Regulator Output
  4. Piezak

    So what are you welding with? (Post your set up here)

    Just bought a Lincoln Square Wave 175.
  5. Piezak

    My Heald Hauler

    Here is my electrical diagram which I've put together. In each conductor in my diagram, where you see a little circle, that is a connection or splice. In a wire it is most likely a splice. The ignition switch has been replaced. It does not have numbered terminals, but is fine. The battery...
  6. Piezak

    My Heald Hauler

    I have a few electrical concerns. It has been patched.
  7. Piezak

    My Heald Hauler

    I have inherited my dad's old Heald Hauler.
  8. Piezak

    So what are you welding with? (Post your set up here)

    Always fascinated with other peoples tools, toys and creativity. Nicely done.
Top