Search results

Currently at 381ft above sea level installed a new vm22 mikuni clone and it runs fine but idke screw backed fully out and it just wants ti take iff with the choke off please help

will try it thank you

So from the axle slot to the engine mounting plate

Where the white lines i drew are?

Let me know if these help

What plate?

I did add a chain tensioner everythings fully alligned and all

I made sure my alignment was straight replaced my bent sprocket thinking about wheel bearings but my wheels seem fine it only does it when i full gas it starts shaking and pops the chain off PLEASE HELP

Yes it is hey buddy

Also can not physically move engine over more

I didnt even think about the spacer being on the wrong side

No

If i flip my clutch it sticks out too much

Think the rear sprockets a lil bent lol

Chain was brand new but after riding for a few days it kept loosening

So im riding chain was way too loose it kept popping off so i got an adjustable mounting plate and made the chain pretty tight( CHAIN STILL KEPT THROWING AND EVENTUALLY SNAPPED) would this keep causing the chain to throw or is the motor not alligned with the sprocket right

I just already drilled engine holes and am hoping they dont interfere

Does this mount to the db30 with no holes needed?

Sweet thank you

hey is it common to pop on deceleration