Search results

Recently I have removed the entire governor of my hisun 196cc. I have also changed the carb to a VM22 slide, switched exhaust, fly wheel and torque converter. (Disclaimer I am using a tachometer to limit my RPMs to<4k before I change the stock rod). After attempting to tune my new carb with what...

Any chance I did not install the new flywheel correctly because the clutch on the jackshift is slipping now as if it’s spinning too fast. Btw thanks for the spark plug fix I assumed that couldn’t have been the problem but it was.

I can feel the “shock” when I hold the metal but no spark even on a new spark plug -just kidding I didn’t ground the boot of the plug to see the spark, stock is rolling now to test aluminum again

Oofta, i will give that a look thank you.

I did check the wiring as well, my spark plug was virtually black. Im afraid i changed the carb and temporarily had too large of a jet where it was running rich. at this point im back tracking but will attempt a new spark plug today with original setup and retry.

switch is on gas is good, not sure how I ruined a spark plug in that amount of time but no spark. I’ll give it a shot thanks

Swapped the stock (ct200u) flywheel to “69730 69736 Aluminum” some cheap option on Amazon. Kept the original timing key since it matches what came with the new wheel. Now I can crank all day maybe get a slight sputter but won’t run. I swapped back to the stock and now I can’t get it to start at...