Looking for $900 or best offer shipped NO CLUTCH
-predator 212 block and crank (gov and low oil removed and sealed)
-arc billet rod
-wiseco flat top piston
-arc light billet flywheel no fins but have plastic fan if needed
-mikuni 28mm slide carb methanol and manifold (ran gas before needs...
Got a new 28mm mikuni slide carb has 3 hoses coming off it... 2 are breathers I believe for the bowl but there's is one more smaller than the other 2 off the bottom of the carb... Not fuelinlet either, that has no hose on it . Any help?
I was wondering if anyone has used a Mikuni 28mm Flat-slide carb on a highly modified Honda GX200 engine? Specifically, what sized main jet did you use burning Gas? I have one and with the stock main jet it runs lean as hell, way leaner than a carb usually runs out of the box. I've used a lot of...
I have a 28mm mikuni that was ran maybe 15 minutes before the block cracked at the kicker so I pulled it, drained it and stuck it in the cupboard...
it's the carb on the right
$75 shipped
will consider a trade for a vm26mm in equal shape..
I have two almost new carbs, both have only had gas in them to start engines and then were removed... The 26mm is a flange mount same as the taper bore mikuni, the 28mm is a vm mikuni spigot mount...
Both are dusty and should be hosed off with with brake clean but other than that they are...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.