basket

Hi All, New here, wasn't sure if this should go in the Baja or Build forum...so here it is. I started off looking for a clean vintage roller to fix up, but decided that for my first foray into the Mini Bike scene, I might use something that had a little less initial value. Enter a stretched...

We were told that it is a Sears Roper and from my research it appears to be close, but not really the same. Everything is chrome (even the 6" rear wheel that we got with it), but the rear suspension is on the seat rather than a swing arm. The front fork has springs and is badly rusted and...

It is a pile of Rupp, just what I wanted:doah: Well its time to dismantle, and see what it is, and go from there. Whoo Hoo!!

Have most parts. I have tbe fenders springs wheels rear sprocket. Frame has the jackshaft setup. 200 bucks for tbe bike and all parts that go to it.w mg

I got this engine in a box with a bike purchase. I was told it runs fine. The PO took it apart with the idea he was going to put a larger piston in it. I guess he ran out of knowledge. :wink: The piston looks good. As does the cylinder. All the small parts are in the small box to the right...

Just picked up whats left of a VT-7, I think. Or is this a VT-8? Older style with only one hole above rear axle bolt for the shock and straight forks. Think I reading somewhere that the VT-7s were blue and the 8s were red but dunno. When I showed it to the wife she called it a VT-zero...

ok so you have the old rope pukes out screaming recoil , just no catching . well your balls are dirty and need to be cleaned . heres how we go about doing the tear down and reassembly. ok so standard briggs sprag clutch older type recoil . for the most part there all the same from the lawn...

Unknown mini bike I picked up today in NJ at swap meet in Englishtown. Another shot from the back where you can see the handlebars attach oddly.

Unknown mini bike I picked up today in NJ at swap meet in Englishtown. Note the crazy handlebars

I'm going to look at a Rupp basket case this afternoon. Is there something to look for to determine if it has any particular value or popularity. He says it's a 2.5 hp Briggs that runs and the fork is away being sandblasted. Asking 175 but he'll take an offer. I know nothing about Rupp mini...

the features are as follows 1. handlebars and forks are seperate. not too uncommon. 2. a 2 hp briggs that also says 6.65 cu in 3. the jackshaft looks to have clutch that is setup for a clutch brake. im a noob but im not sure if ive seen this setup before. also the bike is about the size of a...

if he still has it in the morning i think im gonna buy it. mini bike parts

I found this roller Heald VT-5 bike on CL and bought it. It does have straight handle bars and forks so that good, I,m going to need a jack shaft plate for it to make the brake work, If anyone has one they want to sell,also foot pegs,seat,fenders let me know. I did talk Ron and have new axles...

anyone interested in a blown up tec, with charging or headlight coils. call or pm 818-679-0073 for parts. 40 bucks sun valley ca 91352

Pretty much complete Rupp Roadster w/o motor. Looks like it was found at the bottom of a river but is really solid (surface rust only). Was going to restore it but don't have the time! P/U in Upstate NY or ship at your expense! $40 How i got it: Now taken apart but all pieces intact