.....I have a 3/4" clutch, can I make a sleeve (with slot cut in for keyway) so I can utilize the clutch I have for my TEC's 5/8" shaft? Any probs with this, assuming I can get the clutch nice and secure?
i did that on a jackshaft. works fine for me. your key will have to be 3/16x1/4. you really should put a bolt and washer on the end of crank so it cant come off.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.