Bike is a Rupp Scrambler with a Tecumseh HS50 motor.
I broke off the governor shaft at the location where it enters the engine block and now there is not enough length to install the governor arm to the carb. I am assuming the only way to replace this shaft is to remove the side cover to the motor. Is this a difficult job? I don't know if I should drop the motor off at the local lawn mower shop or do this myself. Any advise will be appreciated.
Thanks!
I broke off the governor shaft at the location where it enters the engine block and now there is not enough length to install the governor arm to the carb. I am assuming the only way to replace this shaft is to remove the side cover to the motor. Is this a difficult job? I don't know if I should drop the motor off at the local lawn mower shop or do this myself. Any advise will be appreciated.
Thanks!