Does anybody else have any input on these tires ?

[Fatboy04]

Thank you Fatboy

Be forewarned.... The front tire is the stock size 19 x 7 x 8. The rear is what Kenda calls a "rear" tire and the smallest size for a rear is 19 x 8 x 8. Some on the forum have said they clear but just barely. The chain does not clear the side wall on these MB200 frames. I have been working on the lathe turning a spacer to move the sprocket out 3/16'' for proper clearance. I have that luxury since I am running a jackshaft and can move the drive out wherever it needs to be. On a stock Warrior I cant see it working. I had planned to run these on my MB165 Warrior but have not tried them yet. The clearance may be slightly different between the 2. I don't know.

Doug

THANKS Fatboy04

 

[ole4]

I don't see the tire you are referencing?

 

[FOMOGO]

Ole, hes talking about these Kenda Speedracers.

https://www.denniskirk.com/kenda/re...n=Browse+Abandonment&utm_content=BA+Message+2


FATBOY I did some measuring just for you last night and if you have a MB200 Warrior then the above 19 x 8 x 8 will not clear the chain.

IF you have an MB165 then the above 19 x 8 x 8 will clear the chain, barely.

The 200's have a shorter hub than the 165s by roughly .125.

Doug

 

[Fatboy04]

Thanks, What a site to be a member off. Everybody is so helpful. Mine is a WR65 so I think they might work. It's a lot of money to spend
when the old tires are fine and the might not work. But I really like the looks of that tire.
Thanks Ole and Doug !!