H35 problem.

#1
im rebuilding an H35, and i just put the side cover back on.

i was checking to see if the engine would spin freely, you can spin the flywheel only a little bit until the motor locks up.

what could this be?
 
#2
That is without a doubt your crank and cam shaft hitting each other... It's a tooth off... Thats why it's a great idea to cycle them and physically watch it all happen %100 of it's cycle to make sure, before buttoning them up.....

Wait till it happens on a Briggs bearing crank :angry: You'll blow a funny fuse.. :mellow:
 
Top