Heathkit Hilltopper part needed made, mold, copy?

[minibike dad]

Hi, I need the right side chain guard of the Heathkit Hilltopper part made? measurements? cardboard copy? (wood?) cut out for mold to be made? fiberglass
mold? Any help would be great! I can compensate you for any help. Thanks, minibike Dad

 

[BC1300]

Was it originally light gauge steel? Unless a member can provide measurements from their guard, you may need to make a cardboard replica and visit a sheet metal shop (heating and AC). Most would have a shear, brake, slip roll and hopefully, some skills. Fiberglass would be an option too.

 

[toomanytoys]

They are sheet metal. If I ever get time I could run down and take some pictures with a tape measure of mine.

 

[minibike dad]

Was it originally light gauge steel? Unless a member can provide measurements from their guard, you may need to make a cardboard replica and visit a sheet metal shop (heating and AC). Most would have a shear, brake, slip roll and hopefully, some skills. Fiberglass would be an option too.

Hi, Thank u. If u can give me the measurements of the chain cover, that would b great! Thanks 4 your help!

 

[minibike dad]

They are sheet metal. If I ever get time I could run down and take some pictures with a tape measure of mine.

Hi That would be great! I would appreciate that! Thank u!

 

[toomanytoys]

Hi That would be great! I would appreciate that! Thank u!

I’ll try to get out there to do it. All my vintage bikes are down in the barn at my dads as I don’t have room for all of them at my house.

I had a 2 car attached garage. But my wife made the executive decision that the garage would be turned into 2 bedrooms. So now I have no garage. Just a basement below ground level and I have to push my bikes up and down the stairs to get them outside