Hey everyone, I have been restoring this old Briggs engine for a mini bike project. Before I took it apart to paint it, I replaced the magneto coil, and it fire right up. Once I finished the paint and reassembled it, I tried to start it, and it would not go. I sprayed starter fluid into the intake, and tried to start it, all it did was fire for a few seconds, but didn’t run. The spark plug is new, I replaced the magneto coil, and cleaned the carb thoroughly, I don’t know if the gaskets are the cause of the problem, since I reused the old ones. I am stuck. Fyi, this Briggs does not have a float bowl on the carb. It’s the old style from the 70s
Attachments
-
2 MB Views: 55
-
2 MB Views: 56