HS40 Model 55200H. I believe this is around the early-mid 1980s.
There was no inlet elbow on the engine when I received it. Fuel line was hooked up and had a 90 degree turn into the carb. But I’m assuming there should be an elbow. I’m replacing the fuel line.
Can anyone verify whether the engine should have a 90 degree inlet connector? If so, the part number and I could purchase.
Thanhs so much.
Tom
There was no inlet elbow on the engine when I received it. Fuel line was hooked up and had a 90 degree turn into the carb. But I’m assuming there should be an elbow. I’m replacing the fuel line.
Can anyone verify whether the engine should have a 90 degree inlet connector? If so, the part number and I could purchase.
Thanhs so much.
Tom