Today: broken thread for the inlet manifold: Use to be M6, hole was around 10mm .
I used an epoxy cement, a new screw with grinded head, the manifold to guide the screw (not tighten yet)....
Dead end thread are not easy to repair without a machine shop
I actually like JB Weld for some uses, however, I cannot imagine it holding up for very long with the heat and vibration it is exposed to in that application.
Michael
Test with gas today, gears are changing well....
I will not do more tests, I am starting to rebuilt the new old frame.
I will use the engine as it is, could be a second project went I will have the registration done.
I actually like JB Weld for some uses, however, I cannot imagine it holding up for very long with the heat and vibration it is exposed to in that application.
Michael
I am starting to remove all parts from the old frame...
I will keep the front fork, to be closer as the original type, easier for the registration later (I have no title)...
I will cut the original headlight support and use a new support...
I trashed the old frame . Sunny day and not to cold: starting to rebuilt the fork...
I have new needle bearings to install , after so long some part don't want to come out ...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.