When the right side clutch cover is off the motor and looking at the front of clutch hub there is a big washer with a long pin that sticks into the clutch pack and has little ball bearings on the washer. I need that part plus any shims that go there too. If I remember right they were aviailable in 002, 003, 005 sizes
I could also use a nice right side clutch cover also it has the arrow design on the cover and I could use the 2 wrist pin thrust washers for the 100cc 12mm wrist pin also. Might condider a left side crank case 1/2 if reasonable.
You can email me at ker.c@hotmail.com
Chris
Indpls IN
I could also use a nice right side clutch cover also it has the arrow design on the cover and I could use the 2 wrist pin thrust washers for the 100cc 12mm wrist pin also. Might condider a left side crank case 1/2 if reasonable.
You can email me at ker.c@hotmail.com
Chris
Indpls IN