pz22 has arrived...

[ex21mini]

just got my pz22 + filter. had to really bore out flange holes to get it to fit my Robin ex21(almost ran out of realestate:huh:but got in on there after about an hour+ of careful drilling. used the stock spacerbut had to pull out the old tin snip 4 the fly wheel/ fan cover:hammer:. but over all i am pleased with the new look. pretty soon ill be:smile:..
p.s does any 1 know about throttle links on this carb? i think i have to spot weld a little ball or something to go in to the little about 1/2 barrel around the slide needle??? huh

 

[jimh]

You either have to solder or find a little brass crimp on stop for the end. Just make sure to leave it long enough to let off the throttle completely. A little bit of slack wouldn't hurt as long as you can adjust it at the twist throttle end.