So for my mini bike project I figure wheels and rims are a good idea. So I bought some.
haha.
The rear rim for a CT200 or BT200x has stiff bearings, i popped the rubbers and added more of my own grease, however, the problem appears to be bearings that are pounded in to hard, whereas the centrepiece of the bearing is protruding, meaning the centre is tight up against the rim hub.
Will this wear in over time? I could pop them out a bit, but upon tightening the axle, I figure I'll be back to square one.
I can still rotate them with my finger, but not easily.
Don't worry about it, it's nothing?
haha.
The rear rim for a CT200 or BT200x has stiff bearings, i popped the rubbers and added more of my own grease, however, the problem appears to be bearings that are pounded in to hard, whereas the centrepiece of the bearing is protruding, meaning the centre is tight up against the rim hub.
Will this wear in over time? I could pop them out a bit, but upon tightening the axle, I figure I'll be back to square one.
I can still rotate them with my finger, but not easily.
Don't worry about it, it's nothing?