I really don't think it'll be too bad. I guess the only problem is that my HEMI Predator 212 has been sitting in a box in the basement for 2 years. It'll run for sure but I need to drain the gas and oil before I install it just to save me some time. Once again, thanks for the help.
That's what I'll end up doing. I did one Predator swap already. Installing this 212 onto my Massimo MB200 should be quicker than installing a 212 on my wife's Moto 80. Might end up being just as quick as replacing the shaft too. I just pulled the Hemi 212 out of the box and see that the...
I mean the shaft coming out of the motor where the OEM clutch and the current torque converter are attached to. Yes it broke twice but it broke differently. The first time just the bolt holding the torque converter pulley broke off in the hole we tapped when installing the TAV. I'm sure that...
I have a Massimo MB200 with the 196cc engine. Earlier this summer the bolt holding my torque converter on broke off in the shaft, spilling the torque converter all over the road. I ordered a new pulley, removed the bolt with an easy out, and replaced everything. Everything seemed okay...
So the last two years, our Coleman 100X was the smoothest running mini bike we had and the one that hadn't been ridden much. Not this summer lol. So the last week or so it's been running like crap. I did all the typical simple fixes. I drained the gas tank and replaced it with fresh gas. I...
I was riding Sunday in a field of tall grass. There must've been a low area in the land that I couldn't see because my front tire went down and I flew off. Fortunately I fell into soft grass. I picked my bike up and the handlebars were crooked. I got home to see that my driver's side...
I'm sure it's heat related. My buddy has the same bike I have and we were hauling butt for 22 miles each way at 30-38 mph. I'm also wondering if, while riding at 38 mph, the drive pulley had the belt at it's max diameter and for some reason it started rubbing on the cover. The belt does have...
So I did the torque converter install on my Massimo MB200. Overall I can say it's pretty awesome. My overall satisfication of the mini bike and riding around is much higher. I did a pretty good job of lining up the belt. My foreman and maintenance guy at work both agreed it looked lined up...
If you absolutely have to go with a 79cc your best bet is to look for a well respected automotive shop that specializes in rebuilds. While not a car, an experienced machinist will have no problem taking precise measurements, know how to get maximum power, where to locate parts, fabricate parts...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.